Bose Companion Surround Sound Owner's guide - Page 7
module, location, Controller, Remote, sensor,
View all Bose Companion Surround Sound manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
*it Surround speakers The surround (rear) speakers create an area of sound around the listener. Place them in the back half of your room. Direct the cubes so that you do not pinpoint the exact location of the sound source (see Figure 3). Each surround cable is 50 feet (15 m) long. 1. Place the speakers at the listeners' ear height or higher, if possible. Left 2. Direct the cubes to reflect front sound off one or more surfaces. The longer the path from the speaker to your ear, the better. Center Sass module Right front Figure 3 Speaker placement example 3. Do not direct the sound straight at the listener, if possible. Left surround Rght surround Bass module location Follow these guidelines to select a location for the bass module. Note: To avoid interference with the 7Vpicture, place the bass module at least 3 feet (1m) from the Ti! 1. Place the bass module along the same wall as the TV, or close to the same end of the room as the front speakers (see Figure 3). 2. Select a convenient location - under a table, behind a sofa. Do not allow fumiture or drapes to block the ventilation openings of the bass module. 3. Place the bass module within reach of the audio input cable, speaker cables, and an electric outlet. 4. Select a position for the bass module (see Figure 4). For proper ventilation, place it on the long edge, with the connectors facing the floor. An alternate position is on its largest side, with the bass and treble controls facing up. Do not place the bass module on either end, as shown by the last two views in Figure 4. 5. Once you have selected a position for the bass module, place the four self-adhesive rubber feet near the corners of the bottom surface. The rubber feet provide increased stability and protection from scratches. 6. Aim the port (the round opening) into the room or along the wall to avoid blocking the port or cleating too much bass. 7. For best bass performance, do not place the port at equal distances from any two walls or from a wall and the ceiling. Figure 4 Bass module positions Preferred position Alternate position - Controller location Select a location for the controller, either in view or hidden away. 1. Place the controller close enough to the sound sources (TV, VCR, etc.) to allow for cable length. If you need additional audio and/or video cables to connect all of your components, see your dealer or installer. 2. Place the controller within 30 feet (9 m) of the bass module (the length of the audio input cable). Remote sensor location Place the remote sensor in a location which is convenient for aiming the remote signal, usually above or below your satellite receiver (see Figure 6). Position the black housing of the sensor light in front of the receiver. Slip the cable housing and cable under or over the receiver. Do not block the front of the sensor - it receives remote control signals. CAUTION: Do not cover the ventilation openings of the bass module. The slots on the endprovide ventilation for the built-in electronic circuitry, and should not be blocked. 7