Bose Lifestyle 12 Owner's guide - Page 11

Setting Up Connect the speakers and Lifestyle® music center Once you have selected locations for your music system, connect the speakers. CAUTION: Make sure all components are unplugged from the power outlet before you begin hooking up the system. Connecting the cube speaker arrays to the Acoustimass® module Each speaker cable contains two wires. The wire marked with a red collar is positive (+) and the plain one is negative (-). These wires match the positive (red) and negative (black) terminals on the back of each speaker. To lengthen the cable, use standard RCA extension cables or splice in 18-gauge or thicker cord (connecting + to + and - to -). To purchase cables, see your dealer, electronics store, or call Bose® customer service. Note: The surround cables are joined together for your convenience, providing an easy-touse cable for connecting the surround speakers. To run the cables in different directions from the Acoustimass module, simply pull apart the cables as needed. 1. Match the correct cable to the corresponding speaker location. • Front speaker cables have blue connectors at one end, with L, R, and C molded into the connectors. The red collars on the + wire are labeled LEFT, RIGHT, and CENTER. • Surround speaker cables have orange connectors at one end, with L and R molded into the connectors. The red collars on the + wire are labeled LEFT and RIGHT. 2. Connect the wire end of one speaker cable to the terminals on the rear of the matching cube speaker array. a. Push each terminal tab down, then insert the end of the appropriate wire into the exposed hole. Release the tab to secure the wire. Connect each wire to its corresponding terminal positive to positive (+ to +) and negative to negative (- to -). b. Repeat this step for each of the five cube speaker arrays. (See Figure 5.) Figure 5 Speaker cable connections to the cube speaker array CAUTION: Make sure no strands of wire from any terminal touch any other terminal. Bridged wires create short circuits that affect proper operation of your system. 3. Connect each cable to the corresponding jack on the Acoustimass module. a. Plug the blue connectors into the matching left front, center, and right front jacks. b. Plug the orange connectors into the matching left surround and right surround jacks. AM191409_01_V.pdf December 20, 2001 9