Bose QuietComfort Ultra SoundLink Flex Set Owners Guide 1 - Page 3

REGULATORY AND LEGAL INFORMATION NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the product. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by Bose Corporation could void the user's authority to operate this equipment. This device complies with part 15 of the FCC Rules and with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. This device complies with FCC and ISED Canada ­radiation ­exposure limits set forth for general population. This transmitter must not be co-located or operating in c­ onjunction with any other antenna or transmitter. Meets IMDA Requirements. The product, in accordance with the Ecodesign Requirements for Energy Related Products Directive 2009/125/EC and the Ecodesign for Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2020, is in compliance with the following norm(s) or document(s): Regulation (EC) No. 1275/2008, as amended by Regulation (EU) No. 801/2013. Required Power State Information Standby Power Modes Networked Standby Power consumption in specified power mode, at 230V/50Hz input < 0.5 W Bluetooth < 2.0 W Time after which equipment is ­automatically switched into mode ≤ 20 minutes ≤ 20 minutes Power consumption in networked standby N/A if all wired network ports are connected and all wireless network ports are activated, at 230V/50Hz input < 2.0 W Network port deactivation/activation procedures. Deactivating all networks will enable standby mode. Bluetooth: Deactivate by clearing the pairing list by pressing and holding the Bluetooth button for 10 seconds. Activate by pairing with a Bluetooth source. CAN ICES-3(B)/NMB-3(B) |3 E N G