Boss Audio 742RGB User Manual - Page 3

WIRING RED WHITE RCA OUTPUT FRONT RIGHT SPEAKER JACK RCA OUTPUT FRONT LEFT SPEAKER JACK RCA OUTPUT REAR RIGHT SPEAKER JACK RCA OUTPUT REAR LEFT SPEAKER JACK RED WHITE ANTENNA INPUT FIXDE-ISO CONNECTOR ISO SOCKET SKETCH CONNECTOR A 1. 2. 3. 4. Memory +12V 5. Auto Antenna Output 6. 7. 12V (To Ignition Key) 8. GROUND CONNECTOR B 1. Rear Right Speaker (+) 2. Rear Right Speaker (-) 3. Front Right Speaker (+) 4. Front Right Speaker (-) 5. Front Left Speaker (+) 6. Front Left Speaker (-) 7. Rear Left Speaker (+) 8. Rear Left Speaker (-) SPECIFICATION GENERAL Supply Voltage Current Consumption Power Output Number of channels Unit Dimensions FM SECTION Frequency range Effective sensitivity I.F Frequency AM SECTION Frequency range Effective sensitivity I.F Frequency RCA LINE OUT Pre-Amp Output CD PLAYER System Suitable CDs Frequency characteristics S/N Ratio to CD DC 12 V Max.10A 4 X 60W 2 STEREO channels. 178[W] X 165[D] X 50[H] mm. 7"[W]X6.5"[D]X1.97"[H] 87.5MHz - 107.9MHz(US) 87.5MHz -108.0MHz(EU) 3uV. 10.7MHz. 530KHz - 1710KHz(US) 522KHz - 1620KHz(EU) 40dB. 450KHz 1 V Output MP3 Audio System. MP3, CD,CD-R,CD-RW Disc 20Hz-100Hz | button briefly to play next track. Press the || or |BASS ->TREBLE -> BALANCE -> FADER -> VOLUME-> When selecting a desired audio mode, rotate the VOL knob to adjust the audio effect. In each mode, the waiting time is about 5 seconds, and when the waiting time is over, it returns to the last display mode of tuner or CD mode. The control mode of E.VOL is operated with following numeric display. - VOL: (MIN)00, 01,......46, 47(MAX). - BASS/TRE: -7, -6,...,0,...+6,+7 - BAL: L,I,...,I,...,I,R - FAD: F,I,...,I,...,I,R b) When pressed longer 2 seconds, it show the time then it is activated as cyclical mode of following functions for user's selection. ->CLK 00:00->TA(ON/OFF) -> AF(ON/OFF) -> TA (ALARM/SEEK) ->PI (SOUND/MUTE)->RETUNE (LONG/SHORT)->MASK(DPI/ALL) ->BEEP (ON/OFF) -> USER SET(FLAT/CLASSIC/ROCK/POP) ->VOL(LAST/DEFA) -> EUROPE/AMERICA ->MONO/STEREO (only for FM mode) ->LOUD(ON/OFF) ->LOCAL/DX(only for FM mode) ->BL AUTO(WHITE,ORANGE,YELLOW,RED PURPLE,BLUE,CYAN,GREEN) ->CLK(ON/OFF) ->CLK(12/24)mode->CL ADJ 00'00(you can adjust HOUR or MINUTE by rotate the VOL knob). After selecting the desired mode, rotate the VOL knob to select one setup item of the desired mode. 1) TA [TRAFFIC ANNOUNCEMENT] When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA SEEK will be displayed on LCD for a while. When traffic announcement is transmitted: (1)If the unit is in USB or disc mode, it will switch to radio mode temporarily. Temporarily switch over to an EON linked station when EON detects a traffic announcement on that other program, and TP will be displayed on LCD (2)If volume level is below 20, volume level is raised to 20, and returns to its previous mode and volume level when the traffic announcement is over. (3)If volume is adjusted during traffic announcement, only the traffic announcement volume is valid. * TA interruption function: The current traffic announcement is cancelled by pressing this key. But the TA mode will not be off. * When TA is on, SEEK, (SCAN), AUTO MEMORY function can be received or saved only when traffic program identification code has been received. Page 2