Boss Audio BV9758BI User Manual - Page 10

Radio Operation 1. Enter/exit Touch [Radio] icon in the main interface to enter into the radio interface. Touch icon to return to main interface, and then touch other function icons so as to exit radio mode. 2. MUTE on/off Click icon to switch MUTE on and off. 3. Loudness on/off Click icon so as to turn on/off loudness function. 4. Search/Save radio stations Short press icon to browse the stored radio stations. FM band can save 18 radio stations (Six stations for FM1/FM2/FM3), AM band can save 12 radio stations (Six stations for AM1/AM2). 5. Band selection Click icon so as to switch among FM1, FM2, FM3, AM1, AM2 bands. 6.Turn on/off the Long/Short-range Click icon, the search pattern in the local search (LOC) and remote search (DX) switch between. LOC feature is turned on after the signal is strong enough only to listen to those in good condition and receiving radio station; DX enabled, you can receive remote weak radio signals. Note: This function is available only when FM band is selected. 7. Stereo on/off When receiving stereo signals, click icon to turn on/off stereo. 8. TA (Receive traffic information) ON: When the traffic station is turned on, the radio will automatically search for traffic stations. After a station is searched, screen displays "TP". Only when traffic information is broadcasted can it be received, after traffic information is completed, the radio will automatically switch to the previous mode. OFF: Repress [TA] button to close TA function. In other modes, traffic announcement will automatically switch to radio mode, after the traffic announcement is completed, it will automatically switch to the previous mode. 9. AF Touch the button to turn the AF function on/off. AF function is turned on, When the received station signals become weak, the radio will automatically fine-tune to other frequencies. When receiving an emergency announcing, the screen will display warning message. 10. PTY Touch the button the screen displays program types, users can search station according to program type. Note: If the unit does not have RDS function, it has no AF/TA/PTY function. 08 ST. Wheel setting 1. Click on the [ ] icon in the main interface into the SWC. settings interface. 2. The original vehicle to the control line positive, negative with the machine control line in the positive and negative connection. 3. Click the SWC buttons will appear corresponding operating tips, and fundamental operation prompts the SWC feature set. 4. Set function to save the settings and click the Confirm icon to confirm. Note: To modify function settings, repeat procedures 3~4. To reset functions, click Reset icon, all the settings set before shall be cleared, repeat procedures 3~4 for resetting. Other Operation Rear view function In any running state, the video signal can switch to reverse video state when reversing the car, and the system shall return to its initial running state after reversing the car. Warning Do not rely on CCD system completely, please make sure you use direct eyesight while driving. Back rearview system only assists in driving. As the distance range of rearview system is limited, completely relying on the rearview system during driving may cause accidents. Reverse field simulation Rearview backup image 13