Bowflex Xtreme 2 SE Owners Manual - Page 43

Seated Lat Pulldowns, Seated Wide Lat Pulldowns

Page 43 highlights

Back Exercises Seated Lat Pulldowns - Shoulder Adduction (with Elbow Flexion) Muscles worked: Latissimus dorsi, teres major and rear deltoid. Also involves biceps group. Position: Seated - facing machine Accessory: Hand Grips Pulleys: Lat Tower Before You Begin: Remove Leg Extension Key Points: • Maintain good spinal alignment, chest lifted, abs tight and a slight arch in lower back. • Keep lats tightened throughout entire motion. • Do not let grips touch chest. START FINISH START • Hold arms out to sides at shoulder height. Bend elbows 90º, hands slightly less than elbow width. • Grasp hand grips at same width as above, then sit down with arms extending upward. • You may position hips under pulleys but only lean back slightly from hips (not the waist). ACTION • Pull shoulderblades down and together while drawing elbows down to sides, then in, toward trunk. • A t end of motion, arms should be drawn near sides (not touching sides), shoulderblades fully depressed toward hips and forearms up in line with cables. • S lowly return to start position. Allow arms and shoulderblades to move up, w/o relaxing muscles. Seated Wide Lat Pulldowns - Shoulder Adduction (with Elbow Flexion) Muscles worked: Latissimus dorsi, teres major and rear deltoid. Also involves biceps group. Position: Seated - facing machine Accessory: 50" Bent Lat Bar Pulleys: Lat Tower Before You Begin: Remove Leg Extension Key Points: • Do not lose spinal alignment. • Keep lats tightened throughout entire motion. • If you can't complete the exercise with hands in the wide position, bring hands closer together. START FINISH START • Grasp 50" Bent Lat Bar at a comfortable, wide grip, then sit with arms extending up. • You may position hips under pulleys but you must lean back slightly from hips (not the waist). • Maintain good spinal alignment, chest lifted, abs tight and a slight arch in lower back. ACTION • Pull shoulderblades down and together while drawing elbows down to sides, then in, toward trunk. • 50" Bent Lat Bar may not touch chest, but, at end of motion, arms should be drawn near sides (not touching sides), shoulderblades fully depressed toward hips and forearms up in line with cables. • Slowly return to start position, Allow arms and shoulderblades to move fully upward, without relaxing muscles. 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68

Seated Lat Pulldowns
– Shoulder Adduction (with Elbow Flexion)
Muscles worked:
Latissimus dorsi, teres major and rear
deltoid. Also involves biceps group.
Position:
Seated – facing machine
Accessor°:
Hand Grips
Pulle°s:
Lat Tower
Before You Begin:
Remove Leg Extension
Ke° Points:
Maintain good spinal alignment, chest
lifted, abs tight and a slight arch in lower
back.
Keep lats tightened throughout entire
motion.
Do not let grips touch chest.
START
FINISH
Hold arms out to sides at shoulder
height. Bend elbows 90º, hands
slightly less than elbow width.
Grasp hand grips at same width as
above, then sit down with
arms extending upward.
You may position hips under pulleys
but only lean back slightly from hips
(not the waist).
Pull shoulderblades down
and together while drawing elbows
down to sides, then in, toward trunk.
At end of motion, arms should be
drawn near sides (not touching
sides), shoulderblades fully
depressed toward hips and forearms
up in line with cables.
Slowly return to start position. Allow
arms and shoulderblades to move
up, w/o relaxing muscles.
Seated Wide Lat Pulldowns
– Shoulder Adduction (with Elbow Flexion)
Muscles worked:
Latissimus dorsi, teres major and rear
deltoid. Also involves biceps group.
Position:
Seated – facing machine
Accessor°:
50” Bent Lat Bar
Pulle°s:
Lat Tower
Before You Begin:
Remove Leg Extension
Ke° Points:
Do not lose spinal alignment.
Keep lats tightened throughout entire motion.
If you can’t complete the exercise with hands in the
wide position, bring hands closer together.
START
FINISH
Grasp 50” Bent Lat Bar at a
comfortable, wide grip, then sit
with arms extending up.
You may position hips under pulleys
but you must lean back slightly
from hips (not the waist).
Maintain good spinal alignment,
chest lifted, abs tight and a slight
arch in lower back.
Pull shoulderblades down
and together while drawing elbows
down to sides, then in, toward trunk.
50” Bent Lat Bar may not touch
chest, but, at end of motion, arms
should be drawn near sides (not
touching sides), shoulderblades fully
depressed toward hips and forearms
up in line with cables.
Slowly return to start position,
Allow arms and shoulderblades to
move fully upward, without relaxing
muscles.
Back Exercises
START
ACTION
START
ACTION
41