Brother International BAS-366E Programmer Instruction Manual - English - Page 48
Move the work clamp with, when the needle point is at point B of
View all Brother International BAS-366E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
4. Select with and press . 5. Select with and press . Chapter 2 Programming with Help Function 6. Input the zigzag width and the stitch length and press . 3.0 mm is input in the example. Input 030 to make the width and the stitch length to 3.0 mm. To switch input between the stitch length and the width, use . 7. Move the work clamp with . Press when the needle point is at point B of the pattern. To program curves, repeat this step. 8. Press again. 9. Press ESC three times. Inputting the end code 1. Select with and press . 2. Select the end code type with and press . "111" is selected in the example. Press and the work clamp returns to the first stitch(point A). 3. Press . ESC The work clamp returns to the home position. Programmer 47
Programmer
47
Chapter 2 Programming with Help Function
4.
Select
with
and press
.
5.
Select
with
and press
.
6.
Input the zigzag width and the stitch length
and press
.
3.0 mm is input in the example.
Input 030 to make the width and the stitch length to 3.0 mm.
To switch input between the stitch length and the width, use
.
7.
Move the work clamp with
. Press
when the needle point is at point B of the
pattern.
To program curves, repeat this step.
8.
Press
again.
9.
Press
�
ESC
ESC
three times.
2
Inputting the end code
1.
Select
with
and press
.
2.
Select the end code type with
and
press
.
"111" is selected in the example. Press
and the work clamp
returns to the first stitch(point A).
3.
Press
�
ESC
ESC
.
The work clamp returns to the home position.