Brother International BE-1204C Stand Alone Type Instruction Manual - English - Page 41
Holder base optional, Remove 4 bolts [9] from the front of X-feed sash [8].
View all Brother International BE-1204C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
! Holder base (optional) [8] [9] [10] Chapter 1 Preparations of operation [9] [11] [5] [1] [2] [12] [7] [4] Felt Table [6] [3] [1] [3] Y-axis cover 1mm 1mm W1244Q Attaching the holder base frame 1. Set the table. (Refer to "Mounting of Table" on page 1-9.) 2. Insert the frame connecting plate F [4] into the holder base frame L [1], flat frame C6-360 [2] and holder base frame R [3], using bolts and washers. [When using the machine only with the holder base frame(small)] Attach the flat frame S connecting plates L [5] and R [6] to the flat frame S6-360 set [7]. Attach the flat frame S connecting plates L [5] and R [6] to the holder base frames L [1] and R [3], using bolts of 4×12 and washers of middle 4. 3. Remove 4 bolts [9] from the front of X-feed sash [8]. 4. Put the frame connecting plates L [10] and R [11] on the X-feed sash [8]. Fix them with bolts and washers. 5. Check that the clearance between the mounted flat frame C6-360 [2] and the table is even when viewed from the machine front. If adjustments are needed, loosen bolts of the F table support Front [12] and move it in the direction of the arrow. 6. Tighten each bolt securely after the adjustment is completed. BE-1204B-BC • BE-1206B-BC 1-21