Brother International CS-80 Users Manual - English - Page 112

S2_brotherE.book Page 106 Thursday, February 13, 2003 11:03 AM APPENDIX Error messages If the start/stop button is pressed before the sewing machine is correctly set up or if an operation is performed incorrectly, an error message appears in the stitch indicator. Follow the instructions that appear. If you press (Stitch selection key) or do the operation correctly while the error message is displayed, the message disappears. Error Message Probable Cause The start/stop button, reverse/reinforcement stitch button or thread cutter button was pressed while the presser foot was raised. A stitch other than the buttonhole or bar tack stitch was selected and the start/stop button was pressed while the buttonhole lever is lowered. The buttonhole or bar tack stitch was selected and the start/stop button was pressed while the buttonhole lever is raised. The reverse/reinforcement stitch button, needle position button or thread cutter button was pressed while the bobbin winder shaft is moved to the right. The start/stop button was pressed while the foot controller was connected. The motor locked up because the thread is tangled. The start/stop button, reverse/reinforcement stitch button or the thread cutter button was pressed while no thread cassette was installed. You tried to start sewing while the needle is lowered. Operation beep Each time a key is pressed or an incorrect operation is performed, a beep is sounded. I For a correct operation One beep is sounded. I If an incorrect operation is performed Two or four beeps are sounded. I If the machine locks up, for example, because the thread is tangled The sewing machine continues to beep for four seconds. The machine automatically stops. Be sure to check for the cause of the error, and correct it before continuing to sew. 106