Brother International CS7130 Operation Manual - Page 18
Upper threading
View all Brother International CS7130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
KNOWING YOUR SEWING MACHINE 1 Slit 2 Cutter (Cut the thread with the cutter.) Note • If the thread is not correctly inserted through the tension-adjusting spring of the bobbin case, it may cause incorrect thread tension (page 27). CAUTION • When threading the upper thread, carefully follow the instructions. If the upper threading is not correct, the thread may become tangled or the needle may bend or break. • Never use a thread weight of 20 or lower. • Use the needle and the thread in the correct combination. For details on the correct combination of needles and threads, refer to "Needle types and their uses" (page 20). 1 Turn on the sewing machine. 2 Raise the presser foot, using the presser foot lever. 1 1 Tension-adjusting spring 6 Replace the bobbin cover. Memo • You can begin sewing immediately without drawing up the bobbin thread. If you want to draw up the bobbin thread before you start to sew, follow to the procedure in "Drawing up the lower thread" (page 19). Upper threading Set the upper thread and thread the needle. • For details on the needle threader, see page 18. 1 Presser foot lever CAUTION • If the presser foot is not raised, the sewing machine cannot be threaded correctly. 3 Raise the needle in the following way. or 1 Turn the handwheel so that the mark on the wheel points up. 2 Press the Needle position button (for the models equipped with this button). • If the needle is not correctly raised, the sewing machine cannot be threaded. Be sure to raise the needle before threading the sewing machine. 4 Press down on the spool pin lever to swing up the spool pin. Then remove the spool cap. 1 Spool pin 2 Mark on the handwheel 16 1 Spool pin 2 Spool cap