Brother International DCP-1400 Service Manual - Page 112
lever spring
View all Brother International DCP-1400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
1.28 Clutch Levers, Cassette Guide L, and Solenoid (1) Turn the main chassis upside down. (2) Remove the two screws and take off the front underbar (which is shown on page IV-61). (3) Place the main chassis rightside up. (4) Remove the clutch lever FIR by pulling its pawl outwards. (5) Remove the clutch lever spring and clutch lever P/R. (6) Remove the plunger and solenoid release spring. (7) Remove two screws "a" and take off the cassette guide L. (8) Remove screw "b" and take off the solenoid. 0 9 Main chassis Plunger Solenoid release spring (Left) Pawl Clutch lever F/R Square hole Latch Latch Latch 0 0 (Front) Solenoid harness Cassette guide L Solenoid Clutch lever P/R Clutch lever spring "a": Taptite, cup S M3x6 "b": Screw, bind M3x4 ■ Reassembling Notes • Route the solenoid harness through three latches and pass it through the square hole provided in the left-hand plate of the main chassis. IV - 68