Brother International Entrepreneur PR650e Users Manual - English - Page 232
Make sure that each hexagonal screw is, firmly tightened. If any screw remains, loosen, injuries may
View all Brother International Entrepreneur PR650e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
APPENDIX Lightly press down the ring, and then use the 6 Allen screwdriver (large) to tighten the four hexagonal screws on the inside of the ring. Firmly tighten the screws. ■ Preparing the mounting jig Lower the stopper, and then attach the mounting jig to a stable surface, such as a desk. Use a Phillips screwdriver to loosen the two 1 screws, and then lower the stopper in the direction of the arrow. 1 Ring CAUTION ● Make sure that each hexagonal screw is firmly tightened. If any screw remains loosen, injuries may result. Remove the pad inserted in step 5. 7 1 Loosen the screw so that the stopper can be hooked onto the screw and clamped with it. 2 Loosen until the stopper moves. 3 Stopper Tighten the two screws. 2 • Make sure that the stopper is firmly secured. ■ Installing the needle plate spacer Attach the needle plate spacer to the needle plate. 1 Needle plate spacer Attach the mounting jig to a stable mounting surface, such as a desk. Loosen the thumb screw for the mounting jig 3 to open the mounting bracket so that it is wider than the thickness of the mounting surface. • The mounting bracket can be mounted onto a mounting surface with a thickness from 9 mm (3/8 inch) to 38 mm (1-1/2 inches). 230