Brother International HL 1040 Users Manual - English - Page 36
Installing the SIMM, switch and unplug the AC cord from the AC
UPC - 012502525219
View all Brother International HL 1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
CHAPTER 4 OPTIONS Note The HL-1050 can also support DIB graphics with a resolution of 1200 x 600 dpi under Windows 95/98/3.1 with the supplied printer driver. We recommend to expand the printer memory to avoid any memory full error. Note The printer has only one slot for a SIMM upgrade. If you want to increase your printer memory again after you have already installed a SIMM module into the slot, you will need to remove the previously installed SIMM first. For example if you had previously increased the printer memory from the standard 4MB to 12MB by adding an 8MB SIMM and you wish to increase your total memory to 36 MB, you need to remove the installed 8MB SIMM and install a new 32MB SIMM into the printer. Installing the SIMM To install the SIMM, follow these steps: 1. Turn off the power switch and unplug the AC cord from the AC outlet. Disconnect the interface cable (printer cable) from the printer. Fig. 4-3 Unplug the AC Cord and Disconnect the Interface Cable ! Caution Be sure to turn off the power switch and unplug the AC cord to the printer before installing or removing the SIMM to/from the main controller board. 4-7