Brother International HL-1050 Quick Setup Guide - English - Page 24

Drum Lamp, Alarm Lamp, Switch, See REPLACING THE DRUM UNIT.

Get Brother International HL-1050 PDF manuals and user guides View all Brother International HL-1050 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Drum Lamp The Drum lamp indicates the drum unit is nearly at the end of its life. Lamp Off r On q Printer status The drum unit can be used. The drum unit is nearly at the end of its life. Installing a new drum unit turns off this lamp. See "REPLACING THE DRUM UNIT". Alarm Lamp The Alarm lamp blinks to indicate a printer error status such as "Cover Open" and "Memory Full." If any other error occurs, the printer indicates the error by blinking the Alarm lamp with another lamp or by printing an error report.  Note The Ready, Data and Drum lamps are used to indicate printer errors with the Alarm lamp. See "ALARM INDICATIONS AT A GLANCE" in this manual and take corrective action for the error. Switch This switch will be used for the following purposes depending on the situation. Cancel printing If you press the switch during printing, the printer immediately stops printing and ejects the paper. Wake-up If the printer is in sleep mode, pressing the switch wakes it up into the ready state. Form Feed If the Data lamp is on, press the switch. The printer prints any data remaining in the printer memory: this operation is called "Form Feed." Error Recovery If an error occurs, the printer will recover from some errors automatically. If the error does not clear automatically, press the switch to clear the error and continue printer operation. - 22 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
- 22 -
Drum Lamp
The
Drum
lamp indicates the drum unit is nearly at the end of its life.
Lamp
Printer status
Off
The drum unit can be used.
On
●
The drum unit is nearly at the end of its life. Installing a new drum unit
turns off this lamp.
See “REPLACING THE DRUM UNIT”.
Alarm Lamp
The
Alarm
lamp blinks to indicate a printer error status such as “Cover Open” and
“Memory Full.” If any other error occurs, the printer indicates the error by blinking the
Alarm
lamp with another lamp or by printing an error report.
Note
The
Ready
,
Data
and
Drum
lamps are used to indicate printer errors with the
Alarm
lamp.
See “ALARM INDICATIONS AT A GLANCE” in this manual
and take
corrective action for the error.
Switch
This switch will be used for the following purposes depending on the situation.
Cancel printing
If you press the
switch
during printing, the printer immediately stops printing and
ejects the paper.
Wake-up
If the printer is in sleep mode, pressing the
switch
wakes it up into the
ready state.
Form Feed
If the
Data
lamp is on, press the
switch
. The printer prints any data remaining in the
printer memory: this operation is called “Form Feed.”
Error Recovery
If an error occurs, the printer will recover from some errors automatically. If the error
does not clear automatically,
press the
switch
to clear the error and continue printer
operation.