Brother International HL-L3230CDW Online Users Guide HTML - Page 218
Error Message, Cause, Action, Cancel, in Canada, No Paper T1, No Toner, No Tray T1, No Waste Toner
View all Brother International HL-L3230CDW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
Error Message No Paper T1 No Toner No Tray T1 No Waste Toner Out of Memory Print Data Full Print Unable ## Registration Replace Belt Cause Action The machine failed to feed paper from the indicated paper tray. Do one of the following: • Refill paper in the paper tray indicated on the LCD. Make sure the paper guides are set to the correct size. • If paper is in the tray, remove it and load it again. Make sure the paper guides are set to the correct size. • Do not overfill the paper tray. The toner cartridge is not installed or not installed correctly. Remove the toner cartridge and drum unit assembly. Remove the toner cartridge from the drum unit, and reinstall the toner cartridge back into the drum unit. Reinstall the toner cartridge and drum unit assembly back in the machine. If the problem continues, replace the toner cartridge. The paper tray is not installed or Reinstall the paper tray indicated on the LCD. not installed correctly. The waste toner box is not Reinstall the waste toner box. installed or not installed correctly. The machine's memory is full. Press and hold Go for about two seconds and reduce the print resolution. The machine's memory is full. Press Cancel and delete the previously stored secure print data. The machine has a mechanical problem. • Press and hold to turn off the machine, wait a few minutes, and then turn it on again. • If the problem continues, contact Brother Customer Service. Contact Brother Customer Service at: 1-877-BROTHER (1-877-276-8437) (in USA) www.brother.ca/support (in Canada) or to locate a Brother Authorized Service Center, visit: www.brother-usa.com/service Registration failed. • If the error continues, press and hold down to turn off the machine. Wait a few seconds, and then turn on the machine again. Perform the color registration using the control panel. • Install a new belt unit. • If the problem continues, contact Brother Customer Service or your local Brother dealer. It is time to replace the belt unit. Replace the belt unit with a new one. See Related Information: Replace the Belt Unit. 213