Brother International HL-L3230CDW Online Users Guide HTML - Page 220
Error Message, Cause, Action, sided Disabled, Access Denied, Calibration, Cartridge Error
View all Brother International HL-L3230CDW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
HL-L3270CDW Error Message 2-sided Disabled Access Denied Calibration Cartridge Error Condensation Cooling Down Cover is Open Cover is Open Drum ! Cause Action The back cover of the machine is Close the back cover of the machine until it not closed completely. locks in the closed position. The function you want to use is restricted by Secure Function Lock 3.0. Ask your administrator to check your Secure Function Lock Settings. Calibration failed. • Press and hold down to turn off the machine. Wait a few seconds, and then turn it on again. Perform the color calibration again using the LCD. • Install a new belt unit. • If the problem continues, contact Brother Customer Service or your local Brother dealer. The toner cartridge is not installed correctly. Remove the toner cartridge and drum unit assembly for the color that is indicated on the LCD. Take out the toner cartridge, and put it back into the drum unit again. Install the toner cartridge and drum unit assembly back in the machine. If the problem continues, contact Brother Customer Service or your local Brother dealer. Condensation may have formed inside the machine after a room temperature change. Leave the machine turned on. Wait for 30 minutes with the top cover in the open position. Then turn off the machine and close the cover. Turn it on again. The temperature of the inside of the machine is too hot. The machine pauses its current print job and goes into cooling down mode. Wait until the machine has finished cooling down. Make sure all vents on the machine are clear of obstructions. When the machine has cooled down, it will resume printing. The top cover is not completely closed. Open and then firmly close the top cover of the machine. The fuser cover is not completely Close the fuser cover located inside the back closed. cover of the machine. The corona wires on the drum unit Clean the corona wires on the drum unit. must be cleaned. Drum Stop Jam 2-sided It is time to replace the drum unit. The paper is jammed underneath the paper tray or the fuser unit. See Related Information: Clean the Corona Wires. If the problem continues, replace the drum unit with a new one. Replace the drum unit. See Related Information: Replace the Drum Unit. Remove the paper tray or open the back cover to gently remove the jammed paper. 215