Brother International HL1060 Quick Setup Guide - English - Page 13

English: HL-1060 Quick Setup Guide, Body Action 6-1: Prepare Windows 95 for the Printer You need to configure Windows 95 for the printer by installing the printer driver and TrueType™-compatible fonts from the supplied disk into Windows 95. 1. Make sure that your printer is connected to your computer. 2. Turn on your printer. 3. Turn on your computer and start Windows 95. The screen shown on the right should appear. If so, proceed to Step 4, otherwise read the note below. NOTE If Windows 95 does not recognize your printer automatically and does not display the message "New Hardware Found" then you should follow these instructions: 1. Click the Start button and choose Run. 2. Insert the supplied disk for Windows into your floppy disk drive. 3. Type A:SETUP and click the OK button or press the Enter key. After the installer starts, you may skip the following steps and simply follow the instructions that appear on the screen. 4. Make sure that the second option "Driver from disk provided by hardware manufacturer" is checked. 5. Click the OK button. The screen shown on the right appears. 6. Insert the supplied disk for Windows 95 into the floppy disk drive. In most cases, this will be drive A. NOTE If you wish to install from a drive other than drive A, type the drive name in the "Copy manufacturer's files from" box on the screen. 7. Click the OK button. 8. Follow the instructions that appear on the screen. 11