Brother International Innov-is NQ700PRW Operation Manual - Page 91
Using free motion quilting foot C sold, separately with some models
View all Brother International Innov-is NQ700PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Appliqué, Patchwork and Quilt Stitching Hold the quilting foot in place with your right hand, e and tighten the presser foot holder screw using the screwdriver with your left hand. 1 Presser foot holder screw CAUTION • Be sure to securely tighten the screws with the included screwdriver. Otherwise, the needle may touch the quilting foot, causing it to bend or break. CAUTION • When using free motion quilting foot "C", be sure to use the straight stitch needle plate and sew with the needle in middle (center) needle position. If the needle is moved to any position other than the middle (center) needle position, the needle may break, which may result in injuries. S Memo • On models equipped with the free motion sewing mode, the presser foot can be adjusted to the best height for free motion sewing. For details, refer to "Sewing with free motion mode" in the "Basic operations" section. UTILITY STITCHES Use both hands to stretch the fabric taut, and then f move the fabric at a consistent pace in order to sew uniform stitches roughly 2.0 mm - 2.5 mm (approx. 1/ 16 inch - 3/32 inch) in length. Attach the straight stitch needle plate (sold separately a with some models). • For details on attaching the straight stitch needle plate, refer to operation manual supplied with the product. 1 Stitch After sewing is finished, slide the feed dog position g switch lever to (to the right as seen from the rear of the machine) and turn the handwheel to raise the feed dogs. Memo • Do not be discouraged with your initial results. The technique requires practice. ■ Using free motion quilting foot "C" (sold separately with some models) Use the free motion quilting foot "C" with straight stitch needle plate for free motion sewing. Free motion quilting foot "C" 1 Round hole Memo • Notice this needle plate has a round hole for the needle. Slide the feed dog position switch, located at the rear b of the machine on the base, to (to the left as seen from the rear of the machine). a 1 Feed dog position switch (as seen from the rear of the machine) → The feed dogs are lowered. Select . c Remove the presser foot holder. d • For details, refer to "Removing and attaching the presser foot holder" in the "Basic operations" section. Sewing S-31