Brother International MFC 7340 Users Manual - English - Page 122
Start, Error Message, Cause, Action, Cooling Down, Wait for a while, Cover is Open, Disconnected - toner life end
UPC - 012502620624
View all Brother International MFC 7340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Error Message Cooling Down Wait for a while Cover is Open Cover is Open Cover is Open Disconnected Document Jam DR Mode in Use Drum Error Cause Action The temperature of the drum unit or toner cartridge is too hot. The machine will pause its current print job and go into cooling down mode. During the cooling down mode, you will hear the cooling fan running while the LCD shows Cooling Down, and Wait for a while. Make sure that you can hear the fan in the machine spinning and that the exhaust outlet is not blocked by something. If the fan is spinning, remove any obstacles that surround the exhaust outlet, and then leave the machine turned on but do not use it for several minutes. If the fan is not spinning do one of the following: (MFC-7340, MFC-7345N and MFC-7440N only) See Transferring your faxes or Fax Journal report on page 111 before disconnecting the machine so you will not lose any important messages. Then, disconnect the machine from the power for several minutes and then reconnect it. (MFC-7840W only) Disconnect the machine from the power for several minutes, then reconnect it. (The machine can be turned off for approximately 4 days without losing faxes stored in the memory. See Transferring your faxes or Fax Journal report on page 111. The front cover is not closed completely. Close the front cover of the machine. The fuser cover is not closed completely. Close the fuser cover of the machine. The fuser cover is not closed completely or paper was jammed in the back of the machine when you turned on the power. Make sure paper is not jammed inside the back of the machine, and then close the fuser cover and press Start. The other person or other Try to send or receive again. person's fax machine stopped the call. The document was not inserted or fed properly, or the document scanned from the ADF was too long. See Document jams on page 113 or Using the automatic document feeder (ADF) on page 18. The machine is set to Distinctive Ring mode. You cannot change the Receive Mode from Manual to another mode. Set Distinctive Ring to Off. (See Turning off distinctive ring on page 46.) The corona wire on the drum unit Clean the corona wire on the drum unit. (See needs to be cleaned. Cleaning the corona wire on page 122.) The drum unit has reached the end of its life. Replace the drum unit. (See Replacing the drum unit on page 130.) 108