Brother International NX-600 Users Manual - English - Page 149
Symptom, Probable Cause, Remedy, Reference, The upper thread, breaks., The lower thread is
View all Brother International NX-600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES Symptom Probable Cause Remedy The upper thread was not threaded correctly (for example, the spool is not installed correctly, the spool cap is too big for the spool being used, or the thread has come out of the needle bar thread hook). Correct the upper threading. There are knots or tangles in the thread. Remove any knots or tangles. The selected needle is not appropriate for the thread being used. Select a needle that is appropriate for the type of thread being used. The upper thread tension is too tight. Loosen the upper thread tension. The upper thread breaks. The thread is tangled, for example, in the shuttle. Remove the tangle thread. If the thread is tangled in the shuttle, clean the shuttle. The needle is bent or blunt. Replace the needle. The needle is incorrectly installed. Correctly install the needle. The area around the hole in the needle plate is scratched, or has a burr on it. Replace the needle plate. Contact your retailer or the nearest authorized service center. The area around the hole in the presser foot is scratched, or has a burr on it. Replace the presser foot. Contact your retailer or the nearest authorized service center. The shuttle is scratched, or has a burr on it. Replace the shuttle. Contact your retailer or the nearest authorized service center. A bobbin designed specifically for this machine is not used. Incorrect bobbins will not work properly. Only use a bobbin designed specifically for this machine. The bobbin thread is incorrectly installed. Correctly install the bobbin thread. The lower thread is tangled or breaks. The bobbin is scratched or does not rotate smoothly, or has a burr on it. The thread is tangled. Replace the bobbin. Remove the tangled thread and clean the shuttle. A bobbin designed specifically for this machine is not used. Incorrect bobbins will not work properly. Only use a bobbin designed specifically for this machine. Reference page 24 - page 34 page 53 page 140 page 35 - - - page 18 page 22 - page 140 page 18 APPENDIX INDEX Troubleshooting 143