Brother International PJ623 PocketJet 6 Plus Print Engine Quick Setup Guide - - Page 3

Installing the Rechargeable Ni-MH Battery a Open the battery cover by pressing the cover latch. 1 2 1 Battery cover 2 Cover latch b Swing the cover open and remove it. c Gently insert the battery connector into the terminal on the inside of the battery compartment. 3 e While holding onto the ribbon, tilt the rechargeable Ni-MH battery and insert it into the battery compartment. After the rechargeable Ni-MH battery passes the outer edges of the compartment, press it securely into position. Note • Make sure that the side of the rechargeable Ni-MH battery marked "Ni-MH" faces away from the battery compartment, otherwise the battery cover will not close properly. • The rechargeable Ni-MH battery contains a heat sensor that stops the flow of electricity if the battery overheats. f Attach the battery cover to the end of the battery compartment opposite the AC/DC connector. Close and latch the cover. If necessary, gently push the cover latch towards the AC/DC connector until it latches. Note • Be careful that you do not pinch the battery connector cord. • The voltage supplied by the rechargeable Ni-MH battery fluctuates. The printing speed may also fluctuate depending on the voltage. 4 3 Terminal 4 Battery connector d Grasp the battery removal ribbon, which is attached to the inside of the battery compartment. Make sure that enough ribbon is exposed after the rechargeable Ni-MH battery installed so that you can pull the ribbon to remove the battery. 2