Brother International PS-3100 Users Manual - Multi - Page 45

KNOWING YOUR SEWING MACHINE CONNAITRE SA MACHINE A COUDRE CONOZCA SU MÁQUINA DE COSER 1 2 (Model PS-2470, PS-3100) 2 1 1 2 1 2 3 3 (Model PS-2360, PS-2250) 2 31 THREADING THE MACHINE Winding the Bobbin CAUTION • If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin. • Use the spool cap (large, medium, or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the end of the spool. 1. Place the spool of thread on the horizontal spool pin and firmly hold it with a spool cap so that the spool of thread will not turn. Pass the thread through the thread guide as shown following the dotted line on the machine. CAUTION Use only bobbins recommended by the manufacturer of this machine (see page 5). Using other bobbins may result in damage or injury. (Model PS-2470, PS-3100) 2. Place the bobbin on the bobbin winder shaft. Push the bobbin winder shaft to the right. 1 Spring on the shaft 2 Groove of the bobbin * Align the groove of the bobbin with the spring on the shaft. 3. Wind the thread clockwise around the bobbin four or five times, pass the end of the thread through the slit in the bobbin winder seat, and then pull the thread in the direction shown in the illustration. Use the cutter to cut the thread. 3 Bobbin winder seat (Model PS2360, PS-2250) 2. Pass the end of the thread through the hole on the bobbin from the inside. Place the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right. Turn the bobbin clockwise, by hand, until the spring on the shaft slides into the groove of the bobbin. 1 Spring on the shaft 2 Groove of the bobbin 3 Bobbin winder seat 3. While holding the end of the thread, gently depress the foot controller to wind the thread around the bobbin a few times. Then stop the machine. Trim the excess thread above the bobbin. 33