Brother International PocketJet 3 Plus Users Manual - English - Page 39

Page 39 highlights

4. Grasp the battery removal ribbon, which is attached to the inside of the battery compartment. See Figure 12. NOTE: If you forget to hold on to the ribbon, you may accidentally insert the battery on top of it. Then you won't be able to remove the battery by pulling the ribbon. Figure 12. Placing the battery inside the battery compartment 5. While holding onto the ribbon, tilt the battery and place it inside the battery compartment. Once the battery clears the outer edges of the compartment, press it securely into position. Make sure the side of the battery with Ni-MH marked face the outside of the battery compartment. Otherwise, the battery cover will not close properly. NOTE: The side of the battery opposite the warning label contains a heat sensor that stops the flow of electricity if the battery overheats. 6. Attach the battery cover to the end of the battery compartment opposite the AC adapter receptacle. Close and latch the cover. If necessary, gently push the cover latch towards the AC adapter receptacle until it latches. Page 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66

Page 35
4. Grasp the battery removal
ribbon, which is attached to the inside of the battery
compartment.
See Figure 12.
NOTE
:
If you forget to hold on to the ribbon, you may accidentally insert the
battery on top of it.
Then you won’t be able to remove the battery by pulling
the ribbon.
Figure 12.
Placing the battery inside the
battery
compartment
5. While holding onto the ribbon, tilt the battery and place it inside the battery
compartment.
Once the battery clears the outer edges of the compartment, press it
securely into position.
Make sure the side of the battery with Ni-MH marked face the outside of the battery
compartment.
Otherwise, the battery
cover will not close properly.
NOTE
:
The side of the battery opposite the warning label contains a heat sensor
that stops the
ow of electricity if the battery
overheats.
6. Attach the battery
cover to the end of the battery
compartment opposite the AC
adapter receptacle.
Close and latch the cover.
If necessary, gently push the cover
latch towards the AC adapter receptacle until it latches.