Brother International Quattro 6000D Users Manual - English - Page 100
Aligning the Fabric with the Vertical, Stitch Alignment V Foot, Using the Straight Stitch Needle,
View all Brother International Quattro 6000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
SEWING THE STITCHES ■ Aligning the Fabric with the Vertical Stitch Alignment "V" Foot Sew while keeping the right edge of the fabric aligned with a desired position of markings on the vertical stitch alignment "V" foot. You can also use the vertical stitch alignment "V" foot for setting a stitch width using the built-in camera (see page 138). d Grasp both sides of the needle and then slide it toward you. plate cover, a Needle plate cover e Grasp the bobbin case, and then pull it out. a Seam b Vertical stitch alignment "V" foot c Markings ■ Using the Straight Stitch Needle Plate and the Straight Stitch Foot The straight stitch needle plate and the straight stitch foot can only be used for straight stitches (middle needle position stitches). Use the straight stitch needle plate and the straight stitch foot when sewing thin fabrics or when sewing small pieces which tend to sink into the hole of the regular needle plate during sewing. The straight stitch foot is perfect to reduce puckering on lightweight fabrics. The small opening on the foot provides support for the fabric as the needle travels through the fabric. a Bobbin case f Use the disc-shaped with the machine to screw driver included unscrew and remove the regular needle plate. CAUTION • Always use the straight stitch foot in combination with the straight stitch needle plate. a Press the "Needle Position" button to raise the needle and turn the main power to OFF or press . b Remove the needle and the presser holder (see page 55 through 56). foot c Remove the flat bed attachment or the embroidery unit if either are attached. g Set the straight stitch needle plate in place and use the disc-shaped screw driver to tighten the plate. a Round hole Note • Align the two screw holes on the needle plate with the two holes on the machine. Use the disc-shaped screw driver included with the machine to secure the screws in the needle plate. 86