Brother International S-7200B Service Manual - Page 13
Function List, FUNCTION SETTINGS OPERATION PANEL, Function No. 0
View all Brother International S-7200B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3. FUNCTION SETTINGS (OPERATION PANEL) 3-5. Function List Function No. 0 − 15 No. Initial value 0 0 (degrees) 1 0 (degrees) 2 0 3 1 4 0 5 0 6 0 7 0 9 0 11 (NOTE 1) 0 12 0 13 0 14 0 15 0 Setting range -10 - 20 (degrees) -10 - 10 (degrees) 0 - 1 0 - 1 0 - 1 - 0 - 1 0 - 1 0 - 1 0 - 4 0 - 1 0 - 1 0 - 1 0 - 1 Setting details Needle up stop position setting Becomes higher Needle down stop position setting Becomes lower 2243M Becomes lower Becomes higher 2244M Depressing forward when depressed backward (thread trimming) 0: Disabled (depressing forward is enabled after returning to neutral position) 1: Enabled Power supply voltage drop check (reset detection) function 0: Not used 1: Used; "Err 6" is displayed when a voltage drop occurs Buzzer (electronic sound) for panel operation 0: Used 1: Not used (Do not change this setting.) Needle penetration up operation 0: Used 1: Not used Backtack sewing speed 0: Limited by sewing speed control key 1: Not limited by sewing speed control key End backtack sewing speed 0: Separate setting from start backtack sewing speed is possible 1: Setting for start backtack sewing is used Option actuator operation setting 0: Half stitch correction sewing 1: Single stitch correction sewing 2: Single reverse stitch correction sewing (reverse feed) 3: Thread trimming 4: Single end backtack cycle cancel 5: Solenoid-type presser foot lifter is raised (Alternating*) 6: Solenoid-type presser foot lifter is raised (Momentary*) Presser foot status when treadle is returned to neutral after thread trimming 0: Presser foot drops (See NOTE 2) 1: Presser foot does not drop Presser foot status after treadle stops at neutral 0: Presser foot does not lift 1: Presser foot lifts Actuator function 0: Reverse stitch switch during operation, correction sewing switch when stopped 1: Thread trimming switch Slow stop control when treadle is returned to neutral 0: Slow stop control without step operation 1: Above control is not used (NOTE 1) If function No. 69 is set to "3", operation is enabled. (NOTE 2) Presser foot will not drop if DIP switch 1 is set to OFF. *... Enabled if the control box model is MD-741A/751A. (Alternating): The presser foot is raised or lowered each time the optional actuator is pressed. (Momentary): The presser foot is raised only while the optional actuator is being pressed. S-7200B 6