Brother International TD-2125N Raster Command Reference - Page 31

Raster Command Reference ESC i a Switch dynamic command mode ASCII: ESC i a {n1} Hexadecimal: 1B 69 61 {n1} Parameters Definitions of {n}: 0: ESC/P mode (default) 1: Raster mode (Be sure to switch to this mode.) 3: P-touch Template mode Description ⚫ Dynamically switches between the printer's command modes. A printer that receives this command operates in the specified command mode until the printer is turned off. ⚫ The printer must be switched to raster mode before raster data is sent to it. Therefore, send this command to switch the printer to raster mode. ESC i U Additional media information command ASCII: ESC i U w Hexadecimal: 1B 69 55 77 1 {d1...d127} 01 {d1...d127} Description ⚫ Updates the media information for the printer. ⚫ Send to the printer the commands outputted with the "Save Paper Size Commands" function of Paper Size Setup. Note If the media information is the same as when printing was last performed, it is unnecessary to send the additional media information command. "Save Paper Size Commands" function of Paper Size Setup 1. Preparation Install the two listed below. ・Printer driver of the Brother TD-XXXX ・Binary file editor. The data outputted with the "Save Paper Size Commands" function of Paper Size Setup will be a binary file. Therefore, use a binary file editor to display and check the contents of the binary file. - 27 - 4. Printing Command Details