Brother International TD-2135NWB Raster Command Reference - Page 9
Print Data
![]() |
View all Brother International TD-2135NWB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Raster Command Reference 2. Print Data 2.1 Print data overview The print data is constructed of the following: (1) initialization commands, (2) control codes, (3) raster data, and (4) print commands. If the print job consists of multiple pages, (2) through (4) are repeated. (1) Initialization commands Specified only once at the beginning of the job. Sequence Command Name Description/Example 1 Invalidate Sends a 200-byte invalidate command, and then resets the printer to the receiving state. 2 Initialize Initializes for printing. 1Bh, 40h (Fixed) (2) Control codes Added at the beginning of each page and sent for each page. Sequence Command Name Description/Example 1 Switch dynamic command mode Switches the printer to raster mode. 1Bh, 69h, 61h, 01h Updates the media information for the printer. 2 Additional media information command 1Bh, 69h, 55h, 77h, 01h, 127 bytes of media information Note If the media information is the same as when printing was last performed, it is unnecessary to send the additional media information command. 3 Print information command Sets the print information for the printer. For 58-mm-wide continuous length tape on the 300 dpi model: 1Bh, 69h, 7Ah, C6h, 0Ah, 3Ah, 00h, 0Ah, 01h, 00h, 00h, 00h, 00h 4 Various mode settings When the peeler function is enabled: 1Bh,69h,4Dh,10h 5 Specify margin amount Specifies the amount of the margins. For 3 mm margins on the 300 dpi model: 1Bh, 69h , 64h, 23h, 00h 6 Select compression mode Selects the compression mode for raster graphics. To send the data compressed to TIFF format: 4Dh, 02h - 5 - 2. Print Data
![](/manual_guide/products/brother-international-td2125n-raster-command-reference-9cb295a/9.png)