Brother International TD-4420TN FBPL Command Reference - Page 205
Size 4,2.5, Gap 0.12,0, Set Gap 1
![]() |
View all Brother International TD-4420TN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
Example The example below is operated in DOS environment via the parallel port connection to setup the label size, gap distance and sensor sensitivity. C:¥>COPY CON LPT1 SIZE 4,2.5 GAP 0.12,0 SET GAP 1 C:¥> Note: stands for keyboard ENTER key. In the above example, press ENTER key instead of typing in the above example. stands for keyboard Ctrl key. Troubleshooting: Press the FEED key to test. Does the printer stop at the same position on each label without the error light blinking? If not, adjust the setting to a larger number. When adjusting this setting, begin from 0 and then on to higher values incrementally. See Also SIZE, GAP, BLINE 200
![](/manual_guide/products/brother-international-td4420tn-fbpl-command-reference-a4fb318/205.png)
200
Example
The example below is operated in DOS environment via the parallel port connection to setup the label size,
gap distance and sensor sensitivity.
C:¥>COPY CON LPT1<ENTER>
SIZE 4,2.5
<ENTER>
GAP 0.12,0
<ENTER>
SET GAP 1
<ENTER>
<CTRL><Z><ENTER>
C:¥>
Note:
<ENTER>
stands for keyboard
ENTER
key. In the above example, press
ENTER
key instead of typing
<ENTER>
in the above example.
<CTRL>
stands for keyboard
Ctrl
key.
Troubleshooting:
Press the
FEED
key to test. Does the printer stop at the same position on each label without the error light
blinking? If not, adjust the setting to a larger number. When adjusting this setting, begin from
0
and then
on to higher values incrementally.
See Also
SIZE, GAP, BLINE