Brother International XL-3500 Users Manual - English - Page 47
Make sure that you fit the bobbin case
View all Brother International XL-3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Using a coin, remove the two screws. 5 Lift up the needle plate as shown in the illustration, and then slide the needle plate to the left to remove it. Insert the bobbin case so that the projection 8 on the bobbin case aligns with the spring. 1 Use a coin or screwdriver Grasp the bobbin case, and then lift it out to 6 the left. 1 Projection 2 Spring Install the needle plate, sliding it to the right 9 to secure it, and then tighten the screws. Make sure that the tab on the left side of the needle plate is aligned with the notch in the bobbin case. 3 Use the cleaning brush or a vacuum cleaner to 7 remove any dust from the race and its surrounding area. 1 Tab 6 2 Notch 3 Screws Install the needle plate cover. 0 Insert the tabs on the needle plate cover into the notches in the needle plate, and then slide the cover back into position. 1 Cleaning brush 2 Race • Do not apply oil to the bobbin case. CAUTION ● Never use a bobbin case that is scratched; otherwise the upper thread may become tangled, the needle may break, or sewing performance may suffer. For a new bobbin case (part code: XC8993-021), contact your nearest authorized service center. ● Make sure that you fit the bobbin case properly, otherwise the needle may break. 45