Campbell Scientific CR10X CR10X Measurement and Control System - Page 302
TABLE 1.8-3 Deleting Current Datalogger
View all Campbell Scientific CR10X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 302 highlights
TD ADDENDUM SECTION 1. FUNCTIONAL MODES to which memory is cleared on powerup, to set the PakBus ID, and to set communication to full or half duplex. TABLE 1.8-3 Deleting Current Datalogger Program Key entry Display CSI datalogger support software makes use of the ∗D 13:00 ∗D Mode to upload and download programs from a 7A 07:00 computer. Appendix C gives some additional information on Commands 1 and 2 that are used for these operations. You may now enter: 0A Erase active program (i.e., load a blank program; memory allocation When "∗D" is keyed in, the CR10X will display and Final Storage are reset). "13:00". A command (Table 1.8-1) is entered by keying the command number and "A". 1.8.2 PROGRAM TRANSFER WITH STORAGE MODULE TABLE 1.8-1. ∗D Mode Commands Command Description Not supported in Table Data Operating Systems. 1 Send (Print) ASCII Program 1.8.3 FULL/HALF DUPLEX 2 2-3 Load ASCII Program, ∗0 Compile Load ASCII Program, ∗6 Compile # Rings Before Answering Phone Not supported in Table Data Operating Systems. 7 Erase Current Program 10 Set Powerup Options 1.8.4 SET DATALOGGER ID 12 Set Initial Baud Command 8 not supported in Table Data 15 PakBus Address/Routing Table Operating Systems. 16 Memory for General Purpose File 17 PakBus Routing Table 18 PakBus Beacon Interval 19 PakBus Neighbor List 1.8.5 SETTING POWERUP OPTIONS Setting options for the Program on Powerup allows the user to specify what information to If the CR10X program has not been compiled when the command to save a program is entered, it will be compiled before the program is saved. When a program is loaded, it is immediately retain from when the datalogger was last on. This allows Flag/Port status, the User Timer, and the Input/Intermediate Storage to be cleared or not cleared. compiled and run. When a command is complete, "13:0000" is displayed; ∗D must be entered again before another command can be given. Table 1.8-8. Setting Powerup Options Key entry Display TABLE 1.8-2. Program Load Error Codes E 94 E 95 E 96 Program Storage Area full Program does not exist in flash Storage Module not connected or ∗D 13:00 10A 10:0X Where X is the powerup option currently selected. You may now change the option: E 97 E 98 E 99 wrong address Data not encountered within 30 sec. Uncorrectable errors detected Wrong type of file or Editor Error 0A Clears input locations, ports, flags, user timer, and intermediate storage locations. 1A Clears intermediate storage only (leaves Input Storage, Flags/Ports, and User Timer 1.8.1 ERASING CURRENT PROGRAM as is). The 7 command may be used to delete the 2A Doesn't clear anything. current program as show in Table 1.8-3. AD-1-4