Campbell Scientific CR10X TD Operating System Addendum for CR510, CR10X, and C - Page 6

TABLE DATA ADDENDUM AD4 Summary of Differences from the Datalogger Manual: Section Overview Section 1 Section 2 Section 3 Section 4 Section 5 Section 6 Section 7 Section 8 Section 9 Section 10 Section 11 Differences Figure OV2.1-2: See Figure 1.5-1 in Addendum. Table OV3.2-1: See Table OV4.1-1 in TD Addendum. OV4, OV5, OV6 :See TD Addendum. Section 1.5 A Mode is replaced by addendum - the TD loggers allocate memory differently. Section 1.8 - *D Mode is replaced by TD Addendum - TD loggers do not support storeing multiple programs or Storage Modules. PakBus Settings are added to the *D Mode. Replaced entirely by TD Addendum. Section 3.7.1 does not apply to the TD operating system which does not use Output Flag 0. Table 3.8-1 Valid Flag Commands are 11 - 19 to set high and 21- 29 to set Low. Because the TD operating system does not use Flag 0, Commands 10 and 20 are not valid with the TD operating system. Table 3.10-1 TD Addendum. has a corrected version Does not apply: The TD operating system does not support External Storage Peripherals. Does not apply: The communications commands and protocol of the TD operating system is different than that of the standard operating systems. Campbell Scientific provides software for communications; a description of the protocol is beyond the scope of this addendum. Many of the peripherals discussed in section 6 are not supported by the TD operating system. No Change Replaced entirely by TD Addendum. Instruction 18 has some differences in the time options, see addendum. No Change Instructions 73 and 74 have only one option for storing the time of max or min (time is output as a quoted string). Instruction 80 - Set Active Storage Area, is not in the TD operating system. Its functions are included in Instruction 84 - Data Table. Instruction 84 - Data Table, sets the conditions and destination for output data. This instruction is only in the TD operating system (see TD Addendum..) AD-4