Campbell Scientific SVP48 SVP48 Surge Voltage Protector - Page 4

SVP48 Surge Voltage Protector 12 Surge Protectors Mounting Screw Surge Protector End Plate Nylon Grommet SVP48#1 (transient) DIN Rail 14 AWG Ground Wire FIGURE 1. SVP48 with Twelve Surge Suppressors 2. Installation 2.1 Mounting the SVP48 Prepare the SVP48 by mounting up to 22 surge protector plates onto the DIN rail as shown in Figure 1. Place the cover plate on the side of the last surge protector. Tighten the clamp screws (yellow/green terminal) on all but one surge protector. Prepare the enclosure mounting plate to accept the SVP48 by inserting the two square nylon grommets provided into two of the square mounting plate holes, six inches apart, but on the same row or column of holes. Mount the SVP48 to the enclosure mounting plate, centering the mounting holes over the nylon grommets and securing the DIN rail with the two screws provided. 2.2 Ground Connections The SVP48 is provided with a green 14 AWG ground wire for connection to the grounding chuck in the ENC 12/14 and ENC 16/18 enclosures. Remove the 2