Canon 2683B002 User Guide - Page 3
Power-cord Caution
UPC - 013803094954
View all Canon 2683B002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
NOTE: This equipment has been tested and found to comply with the limits fm a Class B digital device. pUl'suant to Pali 15 of the FCC Rules. These limits al'e designed to provide reasonable protection against harmful Interference in a residential installation. This equipment genemtes. uses. and can mdlate mdio fl'equency enel'gy and. if not installed and used in accordance with the instructions. may cause hal'mful interference to radio communications. Howevel'. there is no gual'antee that interfel'ence will not OCCUI' n a pal'ticula( installation. If this eqUipment does cause hal'mful interTer-ence to radiO 01' television reception. which can be determmed by !umlllg t'le equipment off a'ld on. the user is encourageo to t(y to COt'rect tne i 1terferellce by one m more of the followln(J IlleaSUles: - Remient m relocate tile I'eceiving antenna. "I ,.1 . m , - Increase the sepal'ation between the equipment ana I'eceivel'. - Connect the equipment into an outlet on a cil'cuit diffel'ent from that to which the receiver is connected. - Consult the dealer or an expenenced radiolN technician for help. D8,10,l,Un This device compiles with Pal't 15 of the FCC Rules. Opel'atlon IS subject to the following two conditions:(nthis device may 110t cause harmful intel'ference. and(2)this device must accept any interfel'ence received. including intet'fel'ence that may cause undeSired opel'alton. Information to User Alteration or modifications can'ied out without appropriate authorIZation may invalidate the users right to operate the equipment. D8'10'2_En CAUTION: This product satisfies FCC regulations when shielded cables (with Ferrite'cores attached) and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions. use shielded cables (with Ferrite,cores attached) and connectors for connections. D8'10'3b_En If the AC plug of this unit does not match the AC outlet you want to use. the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of thiS unit should be performed only by qualified service personnel. If connected to an AC outlet. the cut'off plug can cause severe electrical shock. Make sure it is properly disposed of aftel' removal. The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long penod of time (for example, when on vacation). D3'4,2,2'la_A_En CAUTION The POWER/MODE but on on this unit will not completely shut off all power from the AC outlet. Since the power cmd serves as the main disconnect device for the unit. you wil need 0 unplug it hom the AC au let to s t down all power. Therefore, make s re the unit as been Installed so hat the power cord can be easily unplugged from the AC outlet in case of an aCCident To avoid fire hazard. the power cord should also be unpiugged from the AC outlet when left unused for a long penod of time (for example, when on vacation), D3-4,2,2'2a_A.En POWER-CORD CAUTION Handle the power cord by the plug, Do not pullout the plug by tugglllg the cOl'd and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock Do not place the unit. a piece of fumiture, etc" on the power cmd. or pinch the cord, Never make a knot In the cOl'd or tie it with othel' cords, The powel' cords should be routed such that they al'e not likely to be stepped on, A damaged power cord can cause a fll'e or give you an electncal shock, Check the power cord once in a while. When you filld it damaged, ask youl' nearest CANON authmized service centel' or your dealel' for a replacement. S002_En When using this product follow the instructions written on the underside of the unit, which concern rated voltage, etc. D3-4'2'2'4_En This product includes FontAvenue® fonts licenced by NEe Corporation. FontAvenue is a registered trademark of NEC Corporation. This product complies with the EMC Directive 2004/108/EC. DH'2'l'9aA_En 3 En