Canon Elura 60 ELURA70/ELURA65/ELURA60 Instruction Manual - Page 139
List of Messages - value
UPC - 013803040166
View all Canon Elura 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
List of Messages Message Explanation E SET THE TIME ZONE, You have not set the time zone, date and time. This message 21 DATE AND TIME appears each time you turn the power on until you set the time zone, date and time. CHANGE THE BATTERY PACK Battery pack is exhausted. Replace or charge the battery 13 pack. THE TAPE IS SET FOR Cassette is protected. Replace the cassette or change the 146 ERASURE PREVENTION position of the protect switch. REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Unload 16 and reload the cassette. CHECK THE DV INPUT DV cable is not connected, or the connected digital device is 85 turned off. CONDENSATION HAS Condensation has been detected in the camcorder. 144 BEEN DETECTED TAPE END Tape reached the end. Rewind the tape or replace the - cassette. CHECK THE CASSETTE You attempted to perform audio dubbing on a tape 88 [REC MODE] recorded in a mode other than the SP mode. CHECK THE CASSETTE You attempted to perform audio dubbing on a tape 88 [AUDIO MODE] recorded in 16-bit or 12-bit 4-channel sound. CHECK THE CASSETTE You attempted to perform audio dubbing on a tape with a 88 [BLANK] blank section. HEADS DIRTY, USE Video heads are dirty. Clean the video heads. 143 CLEANING CASSETTE COPYRIGHT PROTECTED You attempted to play back a copyright protected tape. 85 PLAYBACK IS RESTRICTED COPYRIGHT You attempted to dub a copyright protected tape. May also 85 PROTECTED DUBBING appear when an anomalous signal is received during analog RESTRICTED line-in recording, or during analog-digital conversion of a copyright protected tape. Memory Card Related Messages Message Explanation NO CARD Memory card not is inserted into the camcorder. 92 THE CARD IS SET FOR SD Memory Card is set for erasure prevention. Replace the 92 ERASURE PREVENTION card or change the position of the protect switch. NO IMAGES No images are recorded on the memory card. - CARD ERROR A memory card error occurred. The camcorder cannot record - or play back the image. The error may be temporary. If the message disappears after 4 seconds and flashes red, turn the camcorder off, remove the card and reinsert the card. If changes to green, you can continue recording/playback. CARD FULL No remaining capacity on the memory card. Replace with - another card or erase images. NAMING ERROR File or folder number has reached the maximum value. 95 Additional Information 139