Canon I9100 i9100 Easy Setup Instructions - Page 1

1 Unpack the Printer 1 Carefully remove all items from the box. i 9100 Series Photo Printer 2 Prepare the Printer 1 Remove the shipping tape from the front of the printer. Shipping Tape 2 Plug the power cord into the back of the printer and connect the other end to a power outlet. Start Here Easy Setup Instructions 3 Install the Print Head 1 Remove the print head from its package. Tear at notch to open 2 Remove the orange protective cap from the print head. NOTE: Do not touch the electrical contacts. 4 Install the Ink Tanks 1 Peel back the orange tab and completely remove the plastic wrapper from the Yellow Ink Tank (BCI-6Y). i9100 Series Photo Printer 5 Connect the Printer To Your Computer 1 TURN THE PRINTER OFF. IMPORTANT: Be sure the printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready. 2 Connect one end of the USB cable to the computer, the other to the printer. 2 Twist off and discard the orange protective cap. NOTE: To avoid spilling ink, never press on the sides of an ink tank. Protective cap Paper Rest Documentation and Software Kit i 9100 Series Print Head Power Cord Ink Tanks BCI-6C Cyan BCI-6M Magenta BCI-6BK Black BCI-6Y Yellow BCI-6PC Photo Cyan BCI-6PM Photo Magenta NOTE: USB cable is not included. 3 Press the POWER button. POWER Button POWER Lamp Print Head nozzles Electrical contacts 3 Raise the lock lever on the printer. 4 Open the front cover. The print head holder automatically moves to the center. Remove the protective tape. 4 Slide the print head into the holder. The print head will rest at a slight angle. Protective tape Serial number 5 Lower the lock lever and press it down until it locks into place. Write down the serial number located to the right of the print head. You will need this later to register the product. 3 Insert the ink tank into the correct slot. (Refer to the color guide on the print head). Press down until the ink tank locks into place. USB Cable USB Port 4 Insert the remaining five ink tanks into their assigned slots. 5 Close the front cover, attach the paper rest and extend the paper output tray. Continue with Step 6 on side two.