Canon LV 5210 lv7210_series_basic_cmd.pdf - Page 22
Setting Read COMMAND, Temp Read COMMAND - projector problems
View all Canon LV 5210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Basic Serial Functional Specification for LV-5210/7215/7210 7.6 Setting Read COMMAND COMMAND "CR4" [CR] Detail Get setting status for screen such as Ceiling/Rear. Acceptable "%1" [CR] Response "11" [CR] = Normal Screen Setting "10" [CR] = Rotation around the horizontal setting (Rear& Ceiling ON) %1 "01" [CR] = Rotation around the horizontal setting Rear ON) "00" [CR] = Vertical and right-and left (four directions) reversal setting (status: Ceiling ON) Unacceptable "?" [CR] 7.7 Temp Read COMMAND COMMAND "CR6" [CR] Detail Get the temperature inside a projector. When some temperature sensors are installed in the projector, it is possible to know the temperature all at once. Response Acceptable "%1_%2_%3" [CR] %1=Temperature, sensor 1 %2=Temperature, sensor 2 %3=Temperature, sensor 3 Temperature data form shows as 00.0. When the temperature sinks to -, the first character is "-" like "-05.5" [CR]. When cannot return the temperature data due to hardware problems, the first character is "E" like"E00.0" [CR]. %1 When the status is Stand BY or it is 10 seconds after Power %2 On, depend on projectors, temperature may approach critical %3 temperature due to ballast lamp's residual heat. So, when the status is Stand By or it is 10 seconds after Power On, the process for the abnormal temperature is not executed. The temperature data is " ----" at the time. When some temperature sensors are installed, the projector sends command continuously. "_31.5__35.2__33.4" [CR] There is the first sensor's information, and after one space, there is the second sensor's information. Unacceptable "?" [CR] Page 22