Canon LV-WX300USTI User Manual - Page 64

LED Messages ERROR CODE MESSAGES POWER LED GREEN LAMP LED AMBER TEMP LED RED Power On ON OFF OFF Power Off ON OFF OFF Cooling Flashing OFF OFF Over Temperature OFF OFF ON Thermal Break Sensor error 4 blinks OFF OFF Lamp error OFF ON OFF Fan 1 6 blinks 1 blinks OFF Fan 2 6 blinks 2 blinks OFF Fan 3 6 blinks 3 blinks OFF Fan 4 6 blinks 4 blinks OFF Lamp Door Open 7 blinks OFF OFF DMD error 8 blinks OFF OFF Color wheel error 9 blinks OFF OFF In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart above, please contact your service center. Image Problems Problem: No image appears on the screen 1. Verify the settings on your notebook or desktop PC. 2. Turn off all equipment and power up again in the correct order. Problem: The image is blurred 1. Adjust the Focus on the projector. 2. Press the Auto button on the remote control. 3. Ensure the projector-to-screen distance is within the specified range. 4. Check that the projector lens is clean. Problem: The image is wider at the top or bottom (keystone distortion) 1. Position the projector so it is as perpendicular to the screen as possible. 2. Use the Keystone button on the remote control to correct the problem. Problem: The image is reversed Check the Image Flip H/V setting on the Installation I menu of the OSD. Problem: The image is streaked 1. Set the Frequency and Total Dots settings on the Computer menu of the OSD to the default settings. 2. To ensure the problem is not caused by a connected PC's video card, connect to another computer. Problem: The image is flat with no contrast Adjust the Contrast setting on the Image menu of the OSD. Problem: The color of the projected image does not match the source image. 1. Adjust the Gamma settings on the Image menu of the OSD. - 58-