Canon MultiPASS MP370 MultiPASS MP370/360 Set-Up Sheet - Page 6

Install the MP Drivers. The MP Drivers must be installed on the hard disk of your computer in order to print from or scan images to the computer. In addition to installing the MP Drivers, install the MP Toolbox. Use the MP Toolbox to attach scanned images to e-mail and store them. IMPORTANT • For detailed system requirements, see page 64 of the User's Guide. • When installing the software in Windows 2000, you must have Service Pack 1 or later version installed. • When installing the software in Windows 2000, you must log on as Administrator or have Administrator privileges. • When installing the software in Windows XP, you must log on as Administrator privileges. • If you have an earlier version of the MultiPASS Suite software installed on your computer, uninstall this version before installing the new version. For instructions on uninstallation, see the guides for that version of MultiPASS Suite. • On your computer, close any open software applications, including virus checkers, in advance. For details, see the instruction guide for each software application (or consult the system administrator). • If using the machine with USB 2.0 Hi-Speed mode, you must connect it to a computer standard-equipped with a USB 2.0 Hi-Speed interface. Prepare the Setup CD-ROM (Installation preparation) Turn ON your computer, and start Windows. Insert the Setup CD-ROM into the CD-ROM drive. The setup program should automatically run. If the setup program does not automatically run, click [My Computer], then double-click [setup.exe] or [setup] on the Setup CD-ROM. If the following screen appears: The USB cable is connected. Perform the following steps. 1. Disconnect the USB cable. 2. Click [Cancel]. Click