Canon PIXMA MX340 MX340 series Solución de problemas de configuraci&oac - Page 5

Check Settings Screen is Displayed Check The screen appears when an IP address was not obtained automatically due to incorrect network key or inactive DHCP function. Check 1 If the network key is incorrect, enter the network key again and click Connect (A). • For details on how to check the network key of the access point, refer to the manual supplied with the access point or contact its manufacturer. AB Check 2 Make sure that the DHCP function of the access point is active. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. If the DHCP function is inactive, enable the DHCP function of the access point or specify the IP address of the machine, then click Connect (A). • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • To specify the IP address of the machine, click Set IP Address (B), then follow the procedure in Check 4 of "Set Printer IP Address Screen is Displayed" on page 4. Glossary • Network Key A password required to set to prevent unauthorized access to communication. • DHCP function A function to automatically assign required information (IP address, etc.) to computers, printers or other devices connected to the network. • IP address A numerical identification assigned to each computer or network device connected to a network. Set Printer IP Address Screen is Displayed Check Check 1 Make sure that you follow "Connection Checklist" on page 11, then click Connect (A). B C Check 2 Turn off the access point, turn it back on, then click Connect (A). A Check 3 When obtaining an IP address automatically, make sure that the DHCP function of the access point is active. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Enable the DHCP function of the access point, then click Connect (A). • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Check 4 If the problem is not solved even after following Check 1 to 3, follow the procedure below to specify the IP address. 1 Select Use next IP address (B). 2 Enter the value you want to specify for each of IP Address, Subnet Mask, and Default Gateway or Router (C). 3 Click Connect (A).