Canon PIXMA MX340 MX340 series Solución de problemas de configuraci&oac - Page 6

ENGLISH Glossary • IP address A numerical identification assigned to each computer or network device connected to a network. • DHCP function A function to automatically assign required information (IP address, etc.) to computers, printers or other devices connected to the network. • Subnet mask A number used to distinguish the network and host portions of an IP address. • Default gateway A device required to connect to external networks. The Machine is Not Displayed (Detected) on the Detected Printers List Screen Check Check 1 Make sure that you follow Check 1, 2, 4, 5, 6 and 7 of "Connection Checklist" on page 11, then click Redetect. Check 2 Is the machine connected to a network? • For details on how to check if the machine is connected to a network, select Device settings using the Menu button, then select LAN settings > Print LAN details using the [, ] and OK buttons, then on the printed LAN setting information, make sure that Link Status is set to Active. If the machine is not connected to a network, perform setup again by following the procedures in "10 Set Up a Wireless Connection" on page 34 and onward in the printed manual: Getting Started. Check 3 Is the IP filtering feature enabled on the access point? • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Set the access point to accept the IP address of the machine. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • To check the IP address of the machine, select Device settings using the Menu button, then select LAN settings > Print LAN details using the [, ] and OK buttons, then on the printed LAN setting information, check IP Address. Check 4 When obtaining an IP address automatically, make sure that the DHCP function of the access point is active. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Enable the DHCP function of the access point, then click Redetect. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Check 5 Is the privacy separator feature enabled on the access point? • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Disable the privacy separator feature. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.