Canon PIXMA iP1500 iP1500 Easy Setup Instructions - Page 1

1 Unpack the Printer 1 Carefully remove all items from the box. PIXMA iP1500 Photo Printer Print Head Power Cord Ink Tanks BCI-24 Black BCI-24 Color 2 Prepare the Printer Start Here Easy Setup Instructions 3 Install the Print Head 4 Install the Ink Tanks 1 Remove all shipping tape and clear plastic film from the printer. Shipping Tape 1 Remove the print head from its package. 2 Open the paper support and the front cover. Remove the shipping tape and packing material from the print head holder. Packing Material Print Head Holder Tear at notch to open 2 Remove the orange protective cap. NOTE: Do not touch the electrical contacts or print head nozzles. Electrical Contacts Print Head Nozzles Shipping Tape 3 Raise the gray lock lever on the printer. 1 Remove the black ink tank (BCI-24 Black) from its package and pull off the orange protective cap. NOTE: To avoid spilling ink, do not touch the bottom of the tank once you have removed the protective cap. Protective Cap 2 Insert the black ink tank (BCI-24 Black) into the slot on the right. Then press in until the ink tank clicks into place. IMPORTANT: For correct printer operation, make sure ink tanks are secure in slots. Click Series Photo Printer 5 Connect the Printer And Load Paper 1 Plug the power cord into the back of the printer and connect the other end to a power outlet. IMPORTANT: BE SURE THE PRINTER IS OFF, or the computer will attempt to install the printer driver before the printer is ready. 2 Connect one end of a USB cable to the computer, the other to the printer. 3 Write down the serial number located to the right of the print head holder. You will need this to register the product. 4 Slide the print head into the holder until it is securely seated. Do not press it down 3 Repeat the procedure for the color ink tank (BCI-24 Color), inserting it into the remaining slot. Close the front cover. Serial Number USB Port USB Cable 3 Pinch the paper guide and slide it to the left. Load a sheet of blank paper in the paper support. Slide the guide toward the left edge of the paper. Documentation and Software Kit 5 Lower the lever until it clicks into place. Paper Guide Click Continue with Step 6 on side two.