Canon PIXMA iP3000 iP3000 Easy Setup Instructions - Page 1

1 Unpack the Printer 1 Carefully remove all items from the box. PIXMA iP3000 Series Photo Printer Documentation and Software Kit PIXMA iP3000 Series Print Head Power Cord 2 Prepare the Printer 1 Remove the shipping tape from the front and back of the printer. 2 Plug the power cord into the back of the printer and connect the other end to a power outlet. Press the POWER button. The printer will initialize. POWER Lamp POWER Button Start Here Easy Setup Instructions 3 Install the Print Head 1 Remove the print head from its package. Tear at notch to open 2 Remove the orange protective cap from the print head. NOTE: Do not touch the print head nozzles and the electrical contacts. 3 Lower the front cover. Raise the top cover. Remove the shipping tape and lower the inner cover. Top Cover Inner Cover Print Head Nozzles Electrical Contacts 3 Raise the print head lock lever. Front Cover 4 The print head holder automatically moves to the center. Remove the protective tape. Protective Tape Serial Number 4 Slide the print head into the holder. The print head will rest at a slight angle. 4 Install the Ink Tanks 1 Peel back the orange tab and completely remove the plastic wrapper from the Yellow Ink Tank (BCI-6Y). iP3000 Series Photo Printer 5 Connect the Printer and Load Paper IMPORTANT: Be sure the printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready. 2 Twist off and discard the orange protective cap. NOTE: To avoid spilling ink, never press on the sides of an ink tank. Protective Cap 1 TURN THE PRINTER OFF. 2 Connect one end of the USB cable to the computer, the other to the printer. 3 Insert the ink tank into the correct slot. (Refer to the color guide on the print head holder). Press down until the ink tank clicks into place. click 4 Insert the remaining three ink tanks into their assigned slots. 5 Close the inner cover, then the top cover. Lift open the paper support and extend the paper output tray. Paper Support Top Cover 3 Remove the shipping tape from the paper guide. Pinch the paper guide and slide it to the left. Load a few sheets of blank paper into the auto sheet feeder, then slide the paper guide toward the left edge of the paper. Auto Sheet Feeder Paper Guide Ink Tanks BCI-6C Cyan BCI-6M Magenta BCI-3eBK Black BCI-6Y Yellow 5 Write down the serial number located to the right of the print head holder . You will need this later to register the product. 5 Lower the print head lock lever and press it down until it clicks into place. Serial Number Location click Paper Output Tray Inner Cover NOTE: The printer will perform a print head cleaning. Wait until the POWER lamp displays a steady green light before proceeding. Continue with Step 6 on side two.