Canon VB-H630D Network Camera VB-H43/VB-H630VE/VB-H630D/VB-H730F/VB-M42/VB-M62 - Page 104
Setting View Restrictions, Use the preview frame on the panorama, image to set view restrictions.
View all Canon VB-H630D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
[Wide-angle]: Wide-angle limit of the view restriction. Click [Get value] to load the zoom ratio of the current camera angle. (11)[Display in panorama screen] Apply the current view restriction settings to the panorama screen. At this point, the settings are not yet saved in the camera. Be sure to click [Save settings]. (12)[Restore settings] Clear the settings you have specified on the screen of the tool and restore the settings saved in the camera. (13)[Save settings] Save the set view restriction in the camera. After the view restriction has been set, be sure to save the settings in the camera by clicking [Save settings]. Setting View Restrictions You can set view restrictions by entering values in the view restriction setting entry boxes, or by changing the current settings in the view restriction preview frame of the panorama screen or from the camera angle in the video display area. Select appropriate settings according to the environment in which the camera is operated or the purpose for which it is used. Use the preview frame on the panorama image to set view restrictions. 1 Select the [Apply the view restriction] checkbox. 2 Drag to change the [Pan/tilt preview frame (red frame)], [Telephoto preview frame (yellow frame)], or [Wide-angle preview frame (green frame)] shown on the panorama screen to set view restrictions. When the telephoto/wide-angle preview frames are enlarged/shrunk, the aspect ratio remains the same. At this time, you can also enter view restrictions by entering values in the view restriction setting entry boxes. If you have adjusted the view restriction settings, click [Display in panorama screen]. The settings are reflected in the preview frame of the panorama screen. 3 Click [Save settings]. Confirm that the settings have been applied correctly, and then click [Save settings] to save the settings in the camera. 104 Setting by Loading Position Information from Image in Video Display Area 1 Select the [Apply the view restriction] checkbox. 2 Click the [Obtain/Release Camera Control] button to obtain the control privileges of the camera. 3 Operate the camera to adjust the top edge, bottom edge, left edge, right edge, telephoto, or wide angle to desired positions, and click [Get value] each time. The loaded view restriction can be checked in the view restriction setting entry box or view restriction preview frame. 4 Click [Save settings]. The settings are saved in the camera. Important • If you have changed the camera mounting method, recapture the panorama image and register it again. • Check view restriction settings again if the [Video] > [Video Size Set] settings on the Setting page have been changed. • The panorama screen may be slightly different from the actual image. After view restrictions have been set, be sure to confirm with the VB Viewer that the view restrictions have been reflected correctly. • Confirm the settings using the VB Viewer. (View restrictions are not applied to the video display area of this tool, nor to the Admin Viewer.) • If the image stabilizer or digital zoom setting has been changed, check the view restriction settings again. Note • Even when view restrictions are set, an area outside the view restriction may still appear momentarily when the camera is controlled near the boundary of the view restriction. • To cancel the view restrictions, clear the [Apply the view restriction] checkbox and then click [Save settings]. • If the setting fields are cleared while the [Apply the view restriction] checkbox is selected, the maximum view restriction will be set. • The controllable range and range that can be captured are as follows.