Canon Vb-C60 VB-C60 Operation Guide - Page 155
Initialize the Camera using the Reset Switch
UPC - 013803118063
View all Canon Vb-C60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Appendix Restore the Factory Default Settings Initialize the Camera using the Reset Switch If you have forgotten the IP address or Administrator password of VB-C60, you cannot control the camera via the network. In this case, press the reset switch on the rear of the camera. 1. Power off the camera For information on how to power on/off the camera, refer to "Turning ON / OFF" (➞ d Start Guide P.2-7). 2. Switch on the camera with holding down the reset switch, then keep holding the reset switch for at least 5 seconds The reset switch is recessed from the rear panel. Use a thin tipped object to press the reset switch. All settings will be initialized. Reset Switch If you use the reset switch to initialize VB-C60, all the settings including the networkNote related settings (IP address, subnet mask, and default gateway address) will be initialized. Therefore, you cannot use the camera from the PC connected to the camera via the network after reset. Set the IP address for your environment using "VB Initial Setting Tool v4.0" installed in the PC when initializing the camera (➞ d Start Guide P.2-9). 5-15