Canon XH G1S XH G1S / XH A1S Instruction Manual - Page 146
Recording, Playback, Memory Card Operations, About the LCD screen, Problem, Cause, Solution
UPC - 013803100747
View all Canon XH G1S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Recording Problem Cause Solution A vertical light bar appears on the screen. Bright light in a dark scene may cause a Record in Av mode with an aperture value 61 vertical light bar (smear) to appear. This is in the range F5.6-F8.0. not a malfunction. Viewfinder picture is blurred. Viewfinder is not adjusted. Adjust the viewfinder with the dioptric 19 adjustment lever. Audio is not recorded. The input channel is not set correctly. Set the appropriate input channel. 51 Microphone connected to the XLR terminal Set the switch to ON. 51 needs to be powered by the phantom power. Audio is recorded in a very low level. The switch is set to M, and Adjust the audio level correctly. 51 recording level is set too low. Microphone attenuator is turned on. Set the FRONT MIC ATT. switch or the 51 switch to OFF. Playback Problem Cause Pressing the playback button does not start playback. Camcorder is turned off, or is not set to mode. Cassette is not loaded. Tape is running, but image will not appear Video heads are dirty. on the TV screen. You attempted to play back or dub a copyright protected tape. The video output cable is not connected correctly. While playing back a tape recorded in HDV Video heads are dirty. standard there are brief stops in the playback picture. Solution Set the camcorder to mode. 107 Load a cassette. 25 Clean the video heads. 143 Stop playback/dubbing. - Verify that the video cable is connected - properly. Clean the video heads with a dry cleaning 143 cassette. Memory Card Operations Problem Memory card cannot be inserted. Memory card cannot be recorded. Memory card cannot be played back. Image cannot be erased. flashes red. Cause Solution Memory card was not facing the correct direction. Turn the memory card over and try inserting it again. 26 No memory card. Insert a memory card. 26 Memory card is full. Replace the memory card or erase images. 122 Memory card is not initialized. Initialize the memory card. 124 The folder and file numbers have reached their maximum value. Set [FILE NOS.] to [RESET] and insert a new memory card. 113 The dial or / (card/tape) switch are not set to the correct position. Set the dial to VCR/PLAY and the / (card/tape) switch to . 120 Image is protected. Cancel the protection. 123 On an SDHC or SD memory card, the write- Change the position of the write-protect protect switch is set to the locked position. switch on the memory card to unlock it. 142 Card error occurred. Turn off the camcorder. Remove and reinsert the memory card. Initialize the 124 memory card if flashing persists. About the LCD screen The LCD screen is produced with extremely high-precision manufacturing techniques, with more than 99.99% of the pixels operating to specification. Less than 0.01% of the pixels may occasionally misfire or appear as black, red, green or blue dots. This has no effect on the recorded image and does not constitute a malfunction. 146