Canon i860 Series i860 Easy Setup Instructions - Page 1

1 Unpack the Printer 1 Carefully remove all items from the box. i 860 Series Desktop Photo Printer 2 Prepare the Printer 1 Remove the shipping tape from the front and back of the printer. Shipping Tape 2 Plug the power cord into the back of the printer and connect the other end to a power outlet. Start Here Easy Setup Instructions 3 Install the Print Head 1 Remove the print head from its package. Tear at notch to open 2 Remove the orange protective cap from the print head nozzles. NOTE: Do not touch the electrical contacts or the print head nozzles. 4 Install the Ink Tanks 1 Peel back the orange tab and completely remove the plastic wrapper from the Cyan Ink Tank (BCI-6C). 2 Twist off and discard the orange protective cap. NOTE: To avoid spilling ink, never press on the sides of an ink tank. Protective cap i860 Series Desktop Photo Printer 5 Connect the Printer and Load Paper IMPORTANT: Be sure the printer is off before continuing, or the computer will attempt to install the printer driver before the printer is ready. For USB Port: 1 TURN THE PRINTER OFF. 2 Connect one end of the USB cable to the computer, the other to the printer. Documentation and Software Kit Photo Paper Tray Power Cord 3 Press the POWER button. The printer will initialize. POWER Button POWER Lamp Print Head nozzles Electrical contacts 3 Raise the lock lever on the printer. 4 Open the front cover. The print head holder automatically moves to the center. Remove the protective tape. 4 Slide the print head into the holder. The print head will rest at a slight angle. i 860 Series Print Head Ink Tanks BCI-6BK Black BCI-6Y Yellow BCI-3eBK Black BCI-6M Magenta BCI-6C Cyan Protective tape Serial number 5 Write down the serial number located to the right of the print head holder. You will need this later to register the product. 5 Lower the lock lever and press it down until it clicks into place. click 3 Insert the ink tank into the correct slot. (Refer to the color guide on the print head holder.) Press down until the ink tank clicks into place. USB Cable USB Port For Parallel Port: 1 TURN THE PRINTER OFF. 2 Connect one end of the parallel cable to the computer, the other to the printer. click 4 Insert the remaining ink tanks into their assigned slots. 5 Close the front cover and extend the paper rest and paper output tray. Paper Rest Parallel Cable Secure Wire Clips Parallel Port 3 Pinch the paper guide and slide it to the left. Load a sheet of blank paper in the paper rest. Slide the guide toward the left edge of the paper. Paper Guide Paper Output Tray NOTE: The printer will perform a print head cleaning after the cover is closed. Continue with Step 6 on side two.