Canon imageCLASS MF113w Getting Started Guide - Page 8

To connect via USB, To connect via wired LAN

Get Canon imageCLASS MF113w PDF manuals and user guides View all Canon imageCLASS MF113w manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Quick Setup Configuring the Machine To connect via wired LAN To connect via USB The machine does not come with a LAN cable. Please have one ready, if necessary. 1. Make sure that the computer is connected to a router properly. 2. Check the network settings on the computer. 3. Connect the LAN cable. • After connecting the cable, wait a few minutes (until the IP address is set automatically). En • If a static IP address has been set on the computer, set the machine's IP address manually. 4. Install the driver and software. P.9 "Installing the software" Now you are finished with the configuration of the initial settings. • The machine does not come with a USB cable. Please have one ready, if necessary. • Make sure that the USB cable you use has the following mark. • Do not connect the USB cable before installing the driver. If you did, disconnect the USB cable from the computer, close the dialog box, and then perform the following procedure from step 1. 1. Install the driver and software. P.9 "Installing the software" • When a screen with instructions for connecting the USB cable to the machine is displayed, remove the sticker that covers the USB port. Now you are finished with the configuration of the initial settings. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
Quick Setup
To connect via USB
• The machine does not come with a USB cable.
Please have one ready, if necessary.
• Make sure that the USB cable you
use has the following mark.
• Do not connect the USB cable
before installing the driver. If you did, disconnect
the USB cable from the computer, close the
dialog box, and then perform the following
procedure from step 1.
1.
Install the driver and software.
P.9 "Installing the software"
• When a screen with instructions for
connecting the USB cable to the machine is
displayed, remove the sticker that covers the
USB port.
Now you are finished with the
configuration of the initial settings.
To connect via wired LAN
The machine does not come with a LAN cable.
Please have one ready, if necessary.
1.
Make sure that the computer is connected to a
router properly.
2.
Check the network settings on the computer.
3.
Connect the LAN cable.
• After connecting the cable, wait a few minutes
(until the IP address is set automatically).
• If a static IP address has been set on the
computer, set the machine's IP address
manually.
4.
Install the driver and software.
P.9 "Installing the software"
Now you are finished with the
configuration of the initial settings.
Configuring the Machine
8
En