Canon imagePROGRAF iPF6300S iPF6300S Basic Guide No.1 - Page 37
Access the menu for printhead replacement
View all Canon imagePROGRAF iPF6300S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Access the menu for printhead replacement Replacing the Printhead • When replacing the Printhead immediately after printing, wait a few minutes before replacing it. The metal parts of the Printhead become hot during printing, and there is a risk of burns from touching these parts. • Your hands may become dirty during Printhead replacement. Use the gloves provided with the new Printhead for replacement. • Prepare a new Ink Tank when ink levels are low. • When the remaining capacity of Maintenance Cartridge is low, prepare a new Maintenance Cartridge. 1 Remove any paper that has been advanced by selecting Eject Paper in the Control Panel menu. • When using a roll, rewind it. (→ , Removing the Roll from the Printer) • When using sheets, remove the sheet. (→ , Removing Sheets) 2 Clean inside the Top Cover. (→ , If Paper is Soiled) 3 On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Settings/Adj. tab ( ). Ready OK:Setting/Adj. Menu Maint.C Remain.: 80% Tot.Print Area(m2): 678 • If the Tab Selection screen is not displayed, press the Menu button. 4 Press the OK button. The Set./Adj. Menu is displayed. 5 Press ▲ or ▼ to select Maintenance, and then press the OK button. 6 Press ▲ or ▼ to select Replace P.head, and then press the OK button. 7 Press ▲ or ▼ to select the Printhead for replacement. Select Printhead L when replacing the left printhead and Printhead R when replacing the right printhead. Make sure your selection is correct. 8 Press the OK button. Ink is now filled. After about three minutes, a message is shown on the Display Screen instructing you to open the Top Cover. 37