Canon imagePROGRAF iPF815 iPF815 User Manual Ver.1.00 - Page 911

Cause The roll width set in Fit Roll Paper Width in the printer driver does not match the width of the roll loaded in the printer. Error Message > Messages regarding paper > Corrective Action Hold down the Stop button for a second or more to cancel printing. Make sure the roll width selected in the dialog box displayed when you select Fit Roll Paper Width in the printer driver matches the width of the roll loaded in the printer, and then try printing again. Paper size not detected. Cause Paper has been loaded askew, or warped paper has been loaded. Corrective Action Follow these steps to reload the roll. 1. Lift the Release Lever. 2. Open the Top Cover. 3. Adjust the right edge of the roll to make it parallel to the right Paper Alignment Line. 4. Lower the Release Lever. 5. Close the Top Cover. 6. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK button. Printing will resume, starting from the page on which the error occurred. (See "Loading Rolls in the Printer.") →P.628 If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in until it touches the Roll Holder flange, and reload the Roll Holder in the printer. (See "Attaching the Roll Holder to Rolls.") →P.623 Follow these step to reload a sheet. 13 1. Lift the Release Lever. 2. Open the Top Cover. 3. Adjust the right edge of the sheet to make it parallel to the right Paper Alignment Line and the trailing edge of the sheet to make it paral- lel to the paper alignment line under the Paper Retainer. 895 4. Lower the Release Lever. 5. Close the Top Cover. 6. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK button. Printing will resume, starting from the page on which the error occurred. iPF815 Paper size not detected.