Canton DM 50 Owners Manual - Page 37

Troubleshooting

Get Canton DM 50 PDF manuals and user guides View all Canton DM 50 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

English Troubleshooting Here is an overview of the most common problems. If you have any further questions please contact your Canton dealer, call our Service Hotline on +49 (0) 60 83 28 70 or send us an e-mail at [email protected]. Problem DM System does not turn on. Sound reproduction too soft. DM System does not respond to remote control. No sound reproduction. Possible cause Power cable not connected to the power outlet and /or DM System Volume of DM System set too low. The battery is empty. 1. S ound format of the source device wrongly selected (Digital input "TV" and "DVD") 2. Source device not producing any signal. 3. C able not correctly connected / faulty cable. Solution Check connection. Increase the volume using the "Volume" button. Increase the volume of the source device. Replace battery, observe correct polarity at insertion. 1. P lease check the correct setting of your source device (see Page 6). "DTS" or "Dolby Digital" coded output formats cannot be reproduced. 2. D igital output on the source device not activated (please refer to device instructions). 3. Check the connection of the source device to the DM System and change the cable where necessary. 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
36
Troubleshooting
Here is an overview of the most common problems. If you have any further questions please contact your Canton dealer,
call our Service Hotline on +49 (0) 60 83 28 70 or send us an e-mail at [email protected].
Problem
Possible cause
Solution
DM System does not
turn on.
Power cable not connected to the power outlet
and /or DM System
Check connection.
Sound reproduction
too soft.
Volume of DM System set too low.
Increase the volume using the “Volume” button.
Increase the volume of the source device.
DM System does not
respond to remote
control.
The battery is empty.
Replace battery, observe correct polarity at insertion.
No sound
reproduction.
1. Sound format of the source device wrongly
selected (Digital input “TV” and “DVD”)
1. Please check the correct setting of your source device (see
Page 6). “DTS” or “Dolby Digital” coded output formats
cannot be reproduced.
2. Source device not producing any signal.
2. Digital output on the source device not activated (please
refer to device instructions).
3. Cable not correctly connected / faulty cable.
3. Check the connection of the source device to the DM
System and change the cable where necessary.
English